DRV8825 Stepper Motor Driver Module

Unbranded/Generic

  • Unit price per 

{"one"=>"Only {{ count }} left!", "other"=>"Only {{ count }} left!"}

FEATURES
  • Flux SKU:
    BMAA100083
  • Length (mm):
    20
  • Width (mm):
    15
  • Height (mm):
    12
  • Brand:
    Unbranded/Generic
  • Main Colour:
    Red
  • Country of Manufacture:
    China
  • MPN:
    BMAA100083
  • UPC:
    Does Not Apply
  • Minimum Operating Temperature:
    -40°C
  • Maximum Operating Temperature:
    85°C
  • Number of Items:
    1
  • Pin Pitch:
    2.54mm
  • Logic Level Voltage:
    3.3 - 5V
  • Drive Current:
    2A with heatsink
  • Control Type:
    Step/Direction
  • Step Options:
    1
    1/2
    1/8
    1/16
  • Over heat Protection:
    Yes
  • Chipset MPN:
    DRV8825
  • Noted Circuit Types/Features:
    Adjustable drive current
DESCRIPTION
This module is ideally suited to motor control to your project. This is the DRV8825 chipset module which allows you to build in stepper controlled motors to your projects, controlling the speed and direction with steps and direction. This can be used with a wide range of microcontrollers including Arduino and Raspberry Pi. These are the alternative drivers used in a number of 3D printers and machines.
The driver requires a pulse and a direction, which are supplied through the breakout board. These inputs are then used by the driver to control the current through the loops of the motors. Each pulse is used to turn the motor shaft by a fraction of a rotation. Typically 200 pulses will drive the shaft one whole circle – termed full step mode. This means that every pulse turns the shaft 1.8 degrees. Changing the rate of pulses affects the smoothness of the rotation. The higher the rate is, the smoother the rotation. A greater number of steps allows for finer accuracy of rotation, however it comes at a cost to torque, the force of rotation.
Please do not hesitate to contact us if you require further information regarding the module's operation.
Pin Description
DIR Direction
STEP Step
SLEEP
RESET
MS2 Step setting
MS1 Step setting
MS0 Step setting
ENABLE
GND 0V
FLT Fault
1B Motor
1A Motor
2A Motor
2B Motor
GND 0V
VMOT 8.2 - 45V

We Also Recommend