This is the MB-102 prototyping board that is allows rapid prototyping without the need to solder any components. It is designed to have standard sockets with a pin pitch of 2.54mm, making it compatible with a large range of modules and components. It is solidly constructed to allow repeated use, with a life of 5000 insertions per point. This board makes a fantastic base upon which to wire your project.
The board has a total of 830 points of which 200 run parallel length ways down the board for the purpose of supplying power. While the remaining 630 act as individual 5 pin rows. The rows and columns are labelled to allow accurate tracing throughout your project.
The board comes with a foam sticky backing, allowing it to be stuck on to a surface to prevent it moving around. This however arrives sealed, requiring peeling to attach to a surface.
The board has linking sections on its side to allow combination with other breadboard units to build larger prototyping areas. You can even disconnect the parallel lengths which also have the same connectors.