Breadboard Starter Kit

A small kit that joins a group of useful prototyping components into a single value bundle. It is made up of a large breadboard, a power supply unit and a range of jumper leads with which you will have everything you need to embark on your next project.

The MB-102 prototyping board allows rapid prototyping without the need to solder any components. It is designed to have standard sockets with a pin pitch of 2.54mm, making it compatible with a large range of modules and components. It is solidly constructed to allow repeated use, with a life of 5000 insertions per point. This board makes a fantastic base upon which to wire your project. The board has a total of 830 points of which 200 run parallel length ways down the board for the purpose of supplying power. While the remaining 630 act as individual 5 pin rows. The rows and columns are labelled to allow accurate tracing throughout your project. The board comes with a foam sticky backing, allowing it to be stuck on to a surface to prevent it moving around. This however arrives sealed, requiring peeling to attach to a surface.

This module is ideally suited to powering a prototyping board such as the MB-102 which feature standard sockets with a pin pitch of 2.54mm. The supply is designed to be connected to a USB source or a DC adapter with a 5.5 x 2.1mm plug. When powered, the supply will produce 4 power rails. An onboard switch allows you to select between 3.3 or 5V for your breadboard.

Please do not hesitate to contact us if you require further information regarding the set's operation.