Let's Workshop: — Control

Let's Workshop: Keyestudio IR Receiver Module

Posted by Sebastian Karam on

Let's Workshop: Keyestudio IR Receiver Module

Here is a quick introduction to using the Keyestudio IR Detector module. Hopefully it will provide you with the confidence to intergrate IR light sensing into your project. This example will demonstrate the use of an Arduino UNO in monitoring a digital pin over the range of light levels that an IR detector responds to. Components 1pcs Arduino UNO or Compatible - LCAA100005 1pcs Keyestudio IR Detector Module - BDAA100020 3pcs Male to Female Jumper Cables - GBAA100002 Wiring Wire the one of the two boards to the Arduino as can be seen in the images below, taking care to match...

Read more →

Let's Workshop: Keyes IR Detector Module (Red)

Posted by Sebastian Karam on

Let's Workshop: Keyes IR Detector Module (Red)
This example will demonstrate the use of an Arduino UNO in monitoring an analog pin over the range of light levels that an IR detector responds to.

Read more →